Automation
Equipment for Residential Gates
Underground Motors – Hidden Power
By choice we prefer to use electromechanical motors,
they are sturdy and quiet and particularly complement steel
gate designs. The setting and durability of the foundation
cases, which hold the motors, are watertight to (IP67). Motor
cases need to be installed at least 48 hours before installation
of gates and motors can take place.
Motors are self locking on shutdown, but during a power failure
a simple release lever allows the gates to be opened manually.
The motors can be available in 90 degree, 140 degree or 180
degree opening.
Electromechanical Arms
The option to choose from 11 different operators to meet various
applications and requirements such as:-
Gate dimensions from 1.8 metre (5 ft) to 3metres (9 ft) or
5 metres (15ft)
Various gate weights.
Arms are self locking and may be released into manual use
in case of a power failure. They are simpler to install and
are easily adaptable for gates on rising drives.
Articulated Arms
Articulated Arms are suitable for gates up to 2.3 metres per
wing. They may be installed on to relatively narrow posts
and columns from 20 cm and are particularly recommended for
gates with distances of up to 20 cm (8”) between the
gate hinge and the edge of the column. They are strong, self
locking and in case of a power failure, they can be released
and placed into manual operation.
Sliding Gate Motor
Our 1500 kg weatherproof heavy duty sliding gate motors are
very strong and will accommodate any size of residential sliding
gates. These motors are self locking with stop and partial
opening commands available, allowing optimising and adapting
the gate’s opening according to need. Motors can be
switched into manual in the event of a power failure.
Pedestrian Gate Opener
Created solely for small residential swing gates and pedestrian
gates. The motors can be installed on posts as small as 8
cm (3 ¼’’). The motors are low voltage
with amperometric obstacle detection to prevent gates closing
on pedestrians. They are only available as reversible motors
and therefore require an electric lock to secure the closed
gate.
Control Panel & Enclosure
We use a multifunction control board for up to 2 swing gates.
They have self diagnosis of safety devices and control LED’s
All our electric control equipment is enclosed in a lockable
sheet steel enclosure for safety and security. The enclosure
size is 300mm x 300mm x 200mm rated to IP65. Enclosures can
be mounted on the wall or on a steel frame at the gate area.
Back to Residential |
